Melita CAFFEO CI Serie Manual De Instrucciones página 32

Rinsing the coffee unit (Rinsing)
The appliance performs an automatic
rinsing of the coffee unit when it is
switched on and off. The coffee unit can
also be rinsed in between.
• Place a vessel under outlet 3.
• Call up the Care sub-menu.
• Select Rinsing in the menu.
• Select Start in the menu. The rinsing
starts (hot water will fl ow out of the outlet
during the process).
Rinsing the milk unit (" Easy
Cleaning" programme)
After each preparation of a beverage with
milk, the appliance will prompt you to
rinse the milk unit (Easy Cleaning?). The
Easy Cleaning programme can also be
performed in between.
• Place a vessel under outlet 3.
• Call up the Care sub-menu.
• Select Easy Cleaning in the menu.
• Connect the tube to the outlet and to the
drip tray (Image D).
• Press the rotary switch 10 to confi rm.
The "Easy Cleaning" programme starts
(hot water and hot steam run through
the outlet and the tube during the
process).
Cleaning the milk unit (" Intensive
Cleaning" programme)
With the "Intensive Cleaning" programme,
the milk unit is cleaned thoroughly with a
cleaning agent.
To ensure optimum protection of your
appliance and the best hygiene standards,
it is recommended to perform the
"Intensive Cleaning" programme once a
week.
32
BA_CI_042015.indd 32 BA_CI_042015.indd 32
Only use Melitta cleaning tabs.
®
• Clean the milk tube and the milk outlet
opening.
• Place a vessel (0.5 l capacity) under the
outlet 3.
• Call up the Care sub-menu.
• Select Intensive Cleaning in the menu.
• Fill the milk container with 50 ml of milk
system cleaning agent.
• Then add 450 ml of warm tap water to
the milk container.
• Connect the tube to the milk container
and to the outlet (Image C).
• Press the rotary switch 10 to confi rm.
The "Intensive Cleaning" programme
starts (hot steam and hot cleaning
liquid runs out of the outlet during the
process).
• Subsequently, the programme interrupts
automatically and prompts for rinsing of
the milk container.
• Rinse out the milk container thoroughly.
• Fill the milk container with 0.5 l of tap
water.
• Connect the tube to the milk container
and to the outlet (Image C).
• Press the rotary switch 10 to confi rm.
• Empty the vessel (0.5 l capacity) and
place it under the outlet 3 again.
• Press the rotary switch 10 to confi rm.
The "Intensive Cleaning" programme will
continue (hot water runs out of the outlet
during the process). The appliance is
then ready for operation.
20.04.2015 20:45:12 20.04.2015 20:45:12