Starting Up The Appliance - Melita CAFFEO CI Serie Manual De Instrucciones

Accessories
• 1 milk tube or 1 milk container including
milk tube
(depending on the model)
• 1 Coffee scoop with screw-in aid for the
water fi lter
Before using for the fi rst time
General information
• Only use pure water without
carbonation.
• Use the supplied test strip to determine
the hardness of the water used and set
the water hardness (Page 30).
Information for using for the fi rst
time
When using for the fi rst time, the
appliance may only be switched on
without a Melitta
®

Starting up the appliance

Switching on for the fi rst time
Warning!
Danger of fi re and electric shock
due to incorrect supply voltage,
incorrect or damaged connections
and power cable.
– Ensure that the supply voltage
corresponds to the supply voltage
specifi ed on the identifi cation label of
the appliance. The identifi cation label is
located on the right side of the appliance
behind the cover (Figure B, 13).
– Make sure that the power socket meets
the applicable standards for electrical
safety. If in doubt, contact a qualifi ed
electrician.
– Never use damaged power cables
(damaged insulation, bare wires).
24
BA_CI_042015.indd 24 BA_CI_042015.indd 24
Claris water fi lter.
®
• Place the appliance on a stable, dry and
level surface with suffi cient clearance (at
least 10 cm) to the sides.
• Plug the power cable into a suitable
power socket.
• Press the button to switch on the
appliance.
After switching on, fi rst set the language
and then the time.
• Turn the rotary switch (Figure A, 10)
to selective the respective setting
(language, hour, minute).
• Press the rotary switch to save the each
setting.
After making the settings, fi ll the bean
container:
• Filling the bean container („Filling the
bean container", page 25).
• Press the rotary switch.
Then fi ll the water reservoir:
• Raise the lid of the water reservoir 6 and
pull the water reservoir up and out of the
appliance.
• Fill the water reservoir with fresh tap
water only up to the max. mark.
• Insert the water reservoir into the
appliance.
• Press the rotary switch.
• Place a vessel under outlet 3.
• Press the rotary switch. First, an
automatic rinsing is carried out. The
appliance is ready for operation when
the buttons illuminate.
20.04.2015 20:45:11 20.04.2015 20:45:11