M12 Inserts; M12 Inserts Diagram; Panel Configurations - Chauvet Professional C6 Manual Del Usuario

Setup And Installation

M12 Inserts

The M12 inserts are at each corner on the back of the C6 panel, to provide a mechanism to mount
the panel directly onto a flat surface. When mounting the panel on a flat surface be sure to leave
enough room to allow adequate airflow and a way to see the signal indicator lights. Insert a
separator at each corner between the panel and the surface, with an opening in the center through
which the signal and power indicators remain visible.
The number of panels that can be mounted to any surface depend on the load bearing capacity of
the surface. It is optimal to connect the panel to the surface wherever there is an M12 insert.

M12 Inserts Diagram

M12 Bolts

Panel Configurations

The C6 panels can be connected in any number of configurations using the speego connections on
the edges. However, the panels must all be oriented the same way because they are made up of 4
subpanels, each measuring 0.25 x 0.5 m. These subpanels cannot be mapped differently within the
larger configuration of panels. See
The expected orientation has the panels vertically oriented because vertical orientation works with
any content manager or switcher. The alternate orientation, with the panels oriented horizontally
requires a content manager or switcher that can rotate images. See Orientation.
The C6 panels must all be mounted with the same orientation. The panels do not need to be aligned
by subpanel, but each row of pixels must be aligned. The panels and subpanels can be
mismatched. See
Page 16 of 80
M12 Bolt Inserts
Optional Spacers For Ventilation
Panel Configurations
Lining Up Pixels.
4
Diagrams.
Mounting
Structure
M12 Bolts
C6 User Manual Rev. 2