Speego Bolts; Speego Bolt Diagram; Installation Guidelines - Chauvet Professional C6 Manual Del Usuario

Setup And Installation

Speego Bolts

Speego bolts are very strong steel posts with locking bars at the ends and power-spring tightening
mechanisms. They create a temporary attachment to allow for alignment of the LEDs, and then a
firm and precise connection so the pixels remain aligned properly and create a seamless image.
To attach a speego bolt, do the following:
1. Hold the spring knob and insert the locking bar into the inset.
2. Twist the spring knob counter-clockwise until the locking bar locks into place. This step holds the
panels in place to allow precise alignment of the panels.
3. Align the panels using the LEDs as a reference.
4. Twist the tightening knob clockwise to tighten the connection completely.
To detach a speego bolt, do the following:
1. Twist the tightening knob counter-clockwise to loosen the connection.
2. Twist the spring knob clockwise until the locking bar pops out of place.

Speego Bolt Diagram

Spring Knob
Locking Bar

Installation Guidelines

· Check that all the parts are in the package.
· Make sure all the required and optional accessories for mounting and operation are available for
use.
· Power and test each panel. For more information, see
· When building a suspended installation, work from the top down.
· When building an installation mounted on a surface, align and tighten the panels before affixing
them to the surface.
Page 18 of 80
Tightening Knob
Spring
Speego Inset
Testing the Panels.
C6 User Manual Rev. 2