Monacor SA-160BT Manual De Instrucciones página 11

3) Start the audio replay at the Bluetooth
source and operate the Bluetooth source
as desired.
The buttons
mote control may also be used to operate
the Bluetooth source (
Notes:
1. To allow signal transmission, the source must use
the A2DP profile.
2. To ensure the best audio quality, the source
should support the aptX
Establishing the Bluetooth connection via NFC
If the Bluetooth source supports NFC (Near
Field Communication), the Bluetooth connec-
tion can be most conveniently established by
holding the respective units close together.
Note: It cannot be guaranteed that NFC pairing will
work properly with all sources.
1) Switch on the NFC function at the Blue-
tooth source.
2) If the Bluetooth source is in a protective
sleeve or protective bag, remove the
sleeve/bag; otherwise, it may prevent data
transmission.
3) Hold the section of the Bluetooth source
with the NFC antenna (usually on the rear
side of smartphones/tablet PCs) very
close to the NFC section (6) on the upper
side of the amplifier (max. distance: 3 cm).
NFC pairing will automatically switch on
the Bluetooth function of the Bluetooth
source (if it was switched off).
When NFC pairing is made for the first
time, a message will appear on the display
of the Bluetooth source asking whether the
connection with the "BT Speaker" shall be
established. Confirm this message to pair
the units (LED BLUETOOTH will light up
constantly). Future NFC pairings will not
require any confirmation.
Note: When the units have been paired and
when their NFC sections are held close together
again, the units may be disconnected and the
Bluetooth function at the Bluetooth source may
be switched off.
All rights reserved by MONACOR
may be reproduced in any form or by any means for any commercial use.
, and on the re -
chapter 1.1).
® technology.
® INTERNATIONAL GmbH & Co. KG. No part of this instruction manual
7 Specifications
RMS output power: . . 2 × 30 W/8 Ω
Frequency range: . . . 20 – 20 000 Hz
THD: . . . . . . . . . . . . . < 1 %
S / N ratio: . . . . . . . . . . > 99 dB (A weighted)
Line input, stereo
Impedance: . . . . . . 10 kΩ
Sensitivity: . . . . . . . 660 mV
Connection: . . . . . . RCA jacks
Line output, stereo
Level: . . . . . . . . . . . 1200 mV max.
Connection: . . . . . . 3.5 mm jack
Bluetooth
Version: . . . . . . . . . 2.1
Range: . . . . . . . . . . 10 m
Power supply: . . . . . . 24 V
Ambient temperature: 0 – 40 °C
Dimensions: . . . . . . . 150 × 49 × 122 mm
Weight: . . . . . . . . . . . 610 g
Subject to technical modification.
via power
supply unit provided
and connected to
230 V~ / 50 Hz
(W × H × D)
11