Rear Panel - Sony Trinitron PVM-14M2MDJ Instrucciones De Uso

Rear Panel

AC IN
Note
Before connecting the video equipment, see "Important
safeguards/notices for use in the medical environments" on
page 22.
1 AC IN socket
Connect the supplied AC power cord to this socket.
"⁄" means Alternating Current.
2 LINE A connectors
Line input connectors for the composite video and audio
signals and their loop-through output connectors.
To monitor the input signal fed through these
connectors, press LINE A select button (light on) on the
front panel.
VIDEO IN (BNC)
Connect to the video output connector of a video
equipment, such as a VTR or a color video camera. For
a loop-through connection, connect to the video output
connector of another monitor.
VIDEO OUT (BNC)
Loop-through output of the VIDEO IN connector.
Connect to the video input connector for a VTR or
another monitor.
When the cable is connected to this connector, the
75-ohms termination of the input is automatically
released, and the signal input to the VIDEO IN
connector is output from this connector.
AUDIO IN (phono jack)
Connect to the audio output connector of a VTR or to a
microphone through a suitable microphone amplifier.
For a loop-through connection, connect to the audio
output connector of another monitor.
AUDIO OUT (phono jack)
Loop-through output of the AUDIO IN connector.
Connect to the audio input connector of a VTR or
another monitor.
LINE A
VIDEO AUDIO
IN OUT IN OUT
R/R–Y G/Y
A
IN OUT IN
AUDIO EXT SYNC
R/R–Y G/Y B/B–Y
B
IN IN IN
RGB/COMPONENT
LINE B
Y/C
IN OUT
IN
B/B–Y AUDIO
OUT IN OUT IN
RS-232C
IN IN
(The mark indicates automatic termination.)
3 LINE B connectors
Separated Y/C input connectors, audio input
connectors, and corresponding loop-through output
connectors.
To monitor the input signal fed through these
connectors, press LINE B select button (light on) on the
front panel.
Y/C IN (4-pin mini DIN)
Connect to the Y/C separate output connector of a VTR,
video camera or other video equipment.
Y/C OUT (4-pin mini DIN)
Loop-through output of the Y/C IN connector. Connect
to the Y/C separate input connector of a VTR or another
monitor.
When the cable is connected to this connector, the
75-ohms termination of the input is automatically
released, and the signal input to the Y/C IN connector is
output from this connector.
AUDIO IN (phono jack)
Connect to the audio output connector of a VTR or to a
microphone through a suitable microphone amplifier.
For a loop-through connection, connect to the audio
output connector of another monitor.
AUDIO OUT (phono jack)
Loop-through output of the AUDIO IN connector.
Connect to the audio input connector of a VTR or
another monitor.
c
AUDIO
OUT
EXT SYNC
OUT IN OUT
DC OUT REMOTE 1
8V/0.8A
REMOTE
27