General Characteristics - Cembre HT45 Manual De Uso Y Mantenimiento

1. GENERAL CHARACTERISTICS

– Application range: suitable for installing electrical compression connectors for conductors up
– Crimping force: ......................................................................................................50 kN
– Rated operating pressure: ..................................................................................600 bar
– Dimensions: length ..............................................................................................346 mm
width - (handles closed) ..............................................................130 mm
width - (handles open) ................................................................250 mm
– Weight: (without dies) ..........................................................................................2 kg
– Oil recommended: ......................................................... AGIP ARNICA HI 32
– Safety: the tool is provided with max pressure valve; MPC1 special manometer, is available upon
request to check the correct setting of the valve.
2. INSTRUCTIONS FOR USE
2.1) Preparation
– Select the appropriate die set for the connector.
– Open the latch (22) and release the upper die holder (21).
– Insert one die into the upper die holder (21) and one die into the lower die support (26).
Also, it should be considered that, in case of indent compression, the indentor PA... must be inserted
in the die support (26), whereas the die MA... must be inserted in the upper die holder (21).
– Close the latch.
– Remove the handle holder (01) to release the moveable handle (36).
Ensure that the latch and the upper die holder are fully secured, otherwise damage may occur
during tool operation.
– Insert the conductor into connector.
– Locate the connector between the dies at the desired crimp position.
2.2) Die advancement
– Operate the moveable handle (36) to build up pressure and
close the dies.
The automatic opening of the moveable handle allows the
operation of the tool using one hand, while locating the con-
nector in the desired crimp position with the other hand.
*
The HT45-E tool is the HT45 tool fitted with the plastic case type VAL P1.
3
HYDRAULIC CRIMPING TOOLS
HT45 and HT45-E
to 150 mm (300 MCM)
2
(Ref. to Fig. 2 and 3)
*
SHELL TELLUS OIL TX 32
ENGLISH
(6 sh ton)
(8,700 psi)
(13.6 in.)
(5.1 in.)
(9.8 in.)
(4.4 lbs)
or
or equivalent