Personal Protective Equipment - REXROTH Gabel 400 SET Manual De Instrucciones Mantenimiento

During commissioning
During operation
EMERGENCY STOPS,
malfunctions
During maintenance and
repair
During disposal
Conductivity is only present when the case is plugged into the power supply.
Let the product acclimate itself for several hours before commissioning, otherwise
water may condense.
• Commission the product only if it is installed completely.
• Do not reach into moving parts.
• Check the product for malfunctions.
• Ensure that only authorized personnel do the following within the scope of
intended product use
– Start or operate the system, or intervene in its normal functioning
– Activate adjustment devices on components.
• Only allow persons who are authorized by the system owner to access the
product's direct operating area. This also applies when the product is standing
still.
• Do not stand under moving loads during raising and lowering.
• Make sure that
– There are no obstacles preventing access to the EMERGENCY STOP command
devices.
– All delivery points, workstations and passages remain freely accessible.
• Do not use EMERGENCY STOP command devices for routine stops.
• Regularly check the proper functioning of the EMERGENCY STOP command
devices.
• After an EMERGENCY STOP, in the case of a fault, or any other anomalies, switch
the product off and protect it against being switched on again (disconnect the unit
from the power supply and make sure it cannot be plugged back in).
• An idle system is not a safe system, as stored energy can be released
unintentionally or through improper maintenance procedures.
• Do not reach into moving parts.
• After an EMERGENCY STOP or a malfunction, only switch on the system once the
cause of the fault has been determined and the error resolved.
• Make sure that there are no obstacles blocking access to maintenance and
inspection points.
• Perform the prescribed maintenance work at the intervals specifi ed in section 10,
Maintenance.
• Make sure that no lines, connectors, or components are disconnected as long as
the system is under voltage or a load. Protect the system against being switched
on (disconnect the unit from the power supply and make sure it cannot be plugged
back in).
• Dispose of the product in accordance with the currently applicable national
regulations in your country.

2.7 Personal protective equipment

• Wear appropriate protective equipment (e.g. safety shoes, tight clothing, hairnets
for those with long hair) when working with the product.
As a plant operator, you are responsible for appropriate protective equipment when
working with the product.
All personal protective equipment must be intact.
Notes on Safety
3 842 358 712/2014-01, MPS, Bosch Rexroth AG
9/28