REXROTH Gabel 400 SET Manual De Instrucciones Mantenimiento página 47

The sliding blocks and
screws for mounting the
attachment plate are pre-
assembled in the slider
slots.
Note:
¹) This sliding block is used
as a safety at the bottom
edge and is bonded with
Loctite 601.
Do not loosen or
remove!

Mount the attachment
plate.
Note:
²) The attachment plate
can be mounted up to
60 mm higher.
Only use fl oor rollers
that correspond with
the required height to
ensure a fl oor clearance
of 120 mm once the
rollers reach the safety
zone.

Mount the left and
right fork prongs to the
attachment plate. Align
the fork prongs with the
center axis of the case
lifter.
³) Identifi cation of the
safety zone with a red
cover profi le.
⁴) Warning label (yellow/
black), see page 20.
2
3
)
Fig. 9: Mounting the attachment plate and fork for fl oor roller applications with max. 195 mm
fl oor clearance

Identify the danger areas around the case lifter with yellow and black markings
(see Fig. 1 on page 11).
1
1 )
ISO 4762 M8x14-10.9
3
(4x)
SW6
M =22 Nm
D
4
)
3 842 358 712/2014-01, MPS, Bosch Rexroth AG
Assembly 19/28
3 842 528 735
SW6
1
SW6
M =10 Nm
D
358 709-30