Preparation By The User; Space Requirements - Bosch VLH 2155 Manual De Usuario

en 26 | VLH 2155 | Symbols used
2.4

Preparation by the user

2.4.1

Space requirements

Fig. 3: Recommended work station dimensions
(arrow = direction of travel)
A safety clearance of at least 1 meter must be maintai-
ned in front of and behind the vehicle as well as to the
sides of the lifting platform. There must be sufficient
space at the ends of the lifting platform for driving
vehicles on and off.
Ceiling height: At least 0.1 m higher than the total
height of the lifting platform. For increasing height
of lifting platform:
4.1 m / 4.4 m / 4.7 m / 5.0 m.
|
1 689 978 583 2017-07-14
2.4.2 Construction of foundation
¶
Construction of the foundation following consultation
with Bosch customer service or an authorized
service agent.
Dimensions:
Version
Continuous footing
Individual footing
Grade of concrete:
Specifications
Type
Concrete quality B 4710-1
Surface
Reinforcement, top and bottom
i
Refer to Section 7 for foundation plans.
!
The base plates of the lifting platform must be posi-
tioned as per the foundation plan.
Ground:
R
The ground must comply with the general guidelines
for foundations (Eurocode 7, formerly DIN 1054).
R
In the case of outdoor installation, the ground must
be frost-proof.
!
The lift may not be installed outdoors. At least one
weather-proof enclosure is required.
!
If the lifting platform is anchored to an existing rein-
forced concrete floor, individual verification must be
provided by a structural engineer or building expert!
!
Prior to installation, the condition of the concrete and
ground must be checked by means of trial drilling.
Length x width
1100 mm x 4100 mm
Concrete thickness min.
230 mm
1100 mm x 850 mm (2x)
Concrete thickness min.
500 mm
Designation, value
Uncracked concrete
C 20/25
Horizontal and flat
(slope max. 0.5 %)
BSt 500 M, Q131
Robert Bosch GmbH