Standard Accessories - Hitachi Koki WR 36DA Instrucciones De Manejo

English
L2m Low 2 mode
L1m Low 1 mode
MT Tightening torque (Maximum)
Square drive size
Weight
(According to EPTA-Procedure 01/2003)
kg
Switching ON
Switching OFF
Disconnect the battery
Light section switch
Always ON (turn off after 2 minute)
Light only SW-ON
Always OFF
Clockwise rotation
Counterclockwise rotation
Remaining battery indicator switch
Lights ;
The battery remaining power is over 75%
Lights ;
The battery remaining power is 50% – 75%.
Lights ;
The battery remaining power is 25% – 50%.
Lights ;
The battery remaining power is less than 25%
Blinks ;
The battery remaining power is nearly empty.
Recharge the battery soonest possible.
Blinks ;
Output suspended due to high temperature.
Remove the battery from the tool and allow it to
fully cool down.
Blinks ;
Output suspended due to failure or malfunction.
The problem may be the battery so please
contact your dealer.
Tightening mode selector switch
Tightening mode indicator lamp
Low 1 mode / Low 2 mode
For work that requires fi ne adjustments such as
when tightening small diameter bolts.
Medium mode
For work that requires the power to be
suppressed during tightening.
High mode
For work that requires power and speed during
tightening.
Warning

STANDARD ACCESSORIES

In addition to the main unit (1 unit), the package contains the
accessories listed on page 250.
Standard accessories are subject to change without notice.
APPLICATIONS
Tightening and loosening of all types of bolts and nuts, used
for securing structural items
SPECIFICATIONS
The specifi cations of this machine are listed in the Table on
page 249.
NOTE
Due to HITACHI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect the charger's power cord to the receptacle.
When connecting the plug of the charger to a receptacle,
the charge indicator lamp will blink in red (At 1- second
intervals).
2. Insert the battery into the charger.
Firmly insert the battery into the charger as shown in
Fig. 3 (on page 2).
3. Charging
When inserting a battery in the charger, the charge
indicator lamp will blink in blue.
When the battery becomes fully recharged, the charge
indicator lamp will light up in green. (See Table 1)
(1) Charge indicator lamp indication
The indications of the charge indicator lamp will be as
shown in Table 1, according to the condition of the
charger or the rechargeable battery.
10