Triton TA235CSL Instrucciones De Funcionamiento Y Seguridad página 10

then release the detent latch. A small
movement of the saw motor will allow the
latch to pop up into the detent position.
Tighten both bevel lock knobs.
3. For selecting
other angles, leave
the detent latch
disengaged by pushing
it down and back
towards the motor,
where it has a "lock-
out" position. Firmly tighten both knobs
at the desired angle.
FINE-TUNING BEVEL ANGLE
& STOPS
1. You can fine-tune the calibration scale
and the bevel detent positions by +/-2˚.
2. Make sure the saw is set at 0˚ and the
bevel detent latch is engaged.
3. Loosen the rear bevel lock knob (12), also
loosen the Nyloc nut on the bevel micro
adjustment lever (13) using a 10mm spanner.
4. Adjust the trimmer
to the left or right
until the blade
is square to the
GB
baseplate or to the
Triton table.
5. Tighten the rear bevel lock knob
and Nyloc nut after any adjustments.
For full trim range adjustment ensure
the blade depth is set 2–3mm
(3/32"–1/8") below maximum, for
10 Adjustments
motor clearance. Full depth can be re-set
once the adjustment has been made.
BLADE GUARD LEVER
When performing plunge or pocket
cuts it is best to replace the short
blade guard lever (27) with the long
blade guard lever (28). This will provide better
control when raising the lower blade guard.
To change the lever please do as follows:
1. Loosen and remove the Phillips head
screw holding the short blade guard lever
(27). Also remove the blade guard lever.
2. Fit the long blade
guard lever (28) into
the same position.
3. Replace the Phillips
head screw and
tighten to secure
the long blade guard
lever in position.
4. The long blade guard
lever can now be
used to provide
better control of
the lower guard
when performing
pocket cuts.
RIP FENCE ADJUSTMENT
1. The rip fence (18) can be used on the left
or the right of the blade. Using the rip fence
provides accurate cuts without the need to
work free-hand following pencil lines.
2. Locate the rip fence
into the mounting
slots at the front of
the base plate (8) and
tighten the locking
knob (17) to lock it
at the desired cut
width. For greater