Triton TA235CSL Instrucciones De Funcionamiento Y Seguridad página 7

retracting guard spring. If the guard
and the spring are not operating properly,
they must be serviced before use.
Retracting guard may operate sluggishly
due to damaged parts, gummy deposits, or
a build-up of debris.
• Retracting guard should be retracted
manually only for special cuts such
as "plunge cuts" and "compound
cuts." Raise retracting guard by retracting
handle and as soon as blade enters
the material, the retracting guard
must be released. For all other sawing,
the retracting guard should operate
automatically.
• Always observe that the retracting
guard is covering the blade before
placing saw down on bench or floor.
An unprotected, coasting blade will cause
the saw to walk backwards, cutting
whatever is in its path. Be aware of the
time it takes for the blade to stop after
switch is released.
ADDITIONAL SAFETY
WARNINGS FOR LASER LIGHTS
The laser light/laser radiation used in this
product is Class 2 with maximum 1mW
and 650nm wavelengths. These lasers do
not normally present an optical hazard,
although staring at the beam may
cause
flash blindness.
Do not stare directly at the
laser beam.
A hazard may exist if you deliberately
stare into the beam. Please observe all
safety rules as follows:
• The laser shall be used and
maintained in accordance with
the manufacturer's instructions.
• Never aim the beam at any
person or an object other than
the work piece.
Safety Instructions 7
GB