Astralpool HELO HSX Manual De Uso página 38

Personal setting steam bathing program.
There are 4 memory keys with default steam bath programs:
1. 40 minute bathing time at 40
2. 60 minute bathing time at 45
3. 60 minute bathing time at 50
4. 40 minute bathing time at 50
The steam bath will start by pressing one of the program buttons. The LED above the button indicates which
program is active.
In order to memorize your personal steam bath adjust the time and temperature by using – or + keys and then
press one of the program keys for more than 2 seconds. The program key's LED will flash to indicate a successfully
saved programme.
Flush and rinse
The steam generator's magnetic drain valve will automatically open 15 minutes after the bathing programme has
finished. After the tank has flushed (2 minutes) the drain valve will close and the water solenoid valve will open and
fresh cold water will fill the tank up to the upmost level probe. Once the tank is full, the drain valve will open again
and the tank will drain and remain empty ready for the next use.
During the flush and rinse cycle, the outermost segments of the screen will "go around" in circles.
During the flush and rinse cycle, you cannot start a new bathing programme nor can the cycle be interrupted.
Operation.
1. When turned on, the magnetic valve will open and the unit's tank will fill with water.
2. Once the water reaches the lowest of the level probe, the heating elements will turn on.
3. When the water level reaches the level probe, the magnetic valve will close.
4. As the water level decreases due to steaming and reaches the lower level probe, the steam generator will take
in water again until the water level probes indicate that the tank is full.
5. Steaming will continue for the set time period. When the steam room reaches the set temperature, the heating
elements will turn off. Once the temperature decreases 0.5
will be turned on again.
6. Once the bathing is over, the steam generator will initiate the flush and rinse cycle after 15 minutes of
inactivity.
C. Remote Timing Mode
The system can also be connected to a remote timer that switches on and off the system.
Using this option all the automatic re-starts of the alarm modes are inhibited. When an alarm stops the treatment
for safety reasons during the remote timing mode , the system can be re-started by only the operator.
o
C
o
C
o
C
o
C
o
C below the set temperature, the heating elements
16