cecotec Conga 3390 Manual De Instrucciones página 28

ENGLISH
Wet&Dry tank installation
Recommendation: It is not suggested to use the scrubbing function for the first-time use.
Open the tank's blue silicone lid, fill the tank with water carefully so water does not come out
and close it again.
Make sure the silicone clip is properly closed to avoid water from pilling.
Fig. 9.
Install the tank in the robot following the indicated direction. Make sure the clip is properly
fastened.
Fig. 10.
Attach the mop to the bottom part of the mop bracket with the Velcro.
Fig. 11.
Manually press the clips on both sides of the Wet & dry tank and push it into its correct position.
You will hear a click when it is properly fixed.
Fig. 12.
Fig. 13.
Recommendations:
Do not use the scrubbing function while the robot is unattended.
Remove the Wet & dry tank when the robot is charging or not in use.
If there are carpets in the house, set Restricted Areas to avoid the robot from passing over
them.
Add some drops of cleaning agent (not corrosive) if considered necessary.
To remove the mop bracket, press the release button and pull from it outwards.
Fig. 14.
Warnings:
Using cleaning agents in excess might block water outlets.
In order to achieve perfect scrubbing, it is suggested to moisten the mop before using it.
First cleaning
Once the robot and the charging base are completely installed, follow these steps before
scheduling the first cleaning cycle.
First of all, the robot must be fully charged. It is suggested to allow the robot to charge
overnight. When it is fully charged, it may carry out the first cleaning cycle and save the first
map. To do so, activate Auto cleaning mode and Eco power level. It is very important to follow
these indications for the robot to recognize each and every corner in the house and to create
a complete map.
If the house where the robot is going to be used is too big and the robot runs out of battery, do
not worry. The robot features TotalSurface 2.0 technology, so when it returns to the charging
base, it saves the full map and those that have not been completed. Once it is charged again,
27