Connecting The Power Supply - MT.DERM artyst NR.1 Instrucciones De Uso

Reach into the recess on the under-
E
side of the device and pull the metal
plate off of the rear side of the device.
Fasten the metal plate on the mag-
E
netic surface on the underside of the
device. In the process, ensure that the
edges of the metal plate align with the
shape of the recess.
34 EN
Position the device with the metal
E
plate on a clean, stable and level sur-
face.
The device also has a sturdy base for
operation with the tilt angle.
Adhering the device with the magnetic
surface:
The device can be adhered in a vertical
arrangement or rotated 90°. Conse-
quently, connected cables face down-
wards and can be routed more easily.
NOTICE
Damage to cables and jacks
If cables are already connected to the de-
vice, they can be kinked or damaged during
assembly.
Never kink the cable when adhering the
E
device.
Ensure that all jacks are freely accessi-
E
ble.
Ensure that the device is disconnected
E
from the voltage supply.
Ensure that the metal plate is fastened
E
on the rear side of the device.
Adhere the device to a metallic sur-
E
face with the magnetic surface.
5.2

Connecting the power supply

The device may only be operated with
the power supply designated in the oper-
ating manual of the device. The mains
artyst NO.1