Connecting The Foot Switch (Optional); Connecting The Handpiece; Cleaning And Disinfecting The Equipment - MT.DERM artyst NR.1 Instrucciones De Uso

voltage must correspond to the device
voltage designated on the label of the
power supply.
If a suitable country-specific adapter is
E
not included in the scope of delivery of
the device, contact your local special-
ist retailer (also see chapter 9 on
page 39).
To remove a previous country-specific
adapter, if necessary:
Pull and hold the holder for the
E
adapter back, while simultaneously
lifting the country-specific adapter out
of the recess of the power supply.
To insert the desired country-specific
adapter:
Insert the country-specific adapter in
E
the recess of the power supply as
shown below.
artyst NO.1
Press the adapter onto the holder until
E
it audibly engages.
In order to establish the power supply:
Plug the DC plug of the power supply
E
into the jack for the power supply (
Plug the power supply into the power
E
outlet.
The device starts and the display
shows the logo "artyst" for 3 seconds.
The switch to standby mode is indi-
cated by rectangles running from left
to right.
5.3 Connecting the foot switch
(optional)
Only the foot switch cited in sec-
tion 4.3 on page 32 will ensure safe op-
eration.
Plug the cinch plug of the foot switch
E
into the jack for the foot switch (
5.4

Connecting the handpiece

Insert the plug of the handpiece cable
E
completely into the output socket on
the control unit.
5.5 Cleaning and disinfecting the
equipment
NOTICE
Damage caused by fluid
)
If cleansers or disinfectants get inside the
handpiece, the control unit or the power
supply, a short-circuit can occur. The elec-
trical and mechanical components can
also corrode.
Never immerse the handpiece, control
E
unit or power supply in cleansers or
disinfectants.
Never clean the handpiece, control unit
E
or power supply in autoclaves or ultra-
sonic baths.
Pay attention to compatibility of materi-
E
als when selecting cleansers and disin-
fectants (see chapter 7.2 on page 38).
).
EN 35