Sony WRT-847A Manual De Instrucciones página 12

Parts Identification
4 POWER switch
Turns the transmitter ON or OFF.
When you set this switch to ON without holding down the
SET button, the transmitter enters Transmitting mode, and
the signal of the selected channel is transmitted.
The HOLD switch appears when the POWER switch is set
to ON.
Set the HOLD switch to the lock position to prevent an
accidental power cutoff during microphone operation.
Locking the POWER switch
Slide the HOLD switch to the
right with a ballpoint pen or
similar item.
ON
HOLD
Green line
5 Antenna
6
(GB)
A yellow line appears when
the switch is in the hold
position.
ON
HOLD
Yellow line
6 Battery holder
Insert the batteries here.
For details on inserting the batteries, see "Power Supply"
on page 7.
7 + (+ selection) / – (– selection/reset) buttons
In Setting mode, use these buttons to select the transmitting
channel/frequency, audio gain level, compander time
constant, and RF power level.
Use the – button to reset the accumulated battery use time
indication to 00:00.
For details on Setting mode, see "Settings" from page 8 to
12.
How to press the SET and +/– buttons
+
–
SET
To pess the SET, +/– buttons
use a ballpoint pen or similar
item.