Test Operation - Daikin BRC1E72 Manual Del Usuario

Notes) 1. Field settings are normally applied to the entire remote control group, however if individual
indoor units in the remote control group require specifi c settings or for confi rmation that
settings have been established, utilize the mode number in parenthesis.
2. Any features not supported by the installed indoor unit will not be displayed.
3. When mode 10-2-01 is selected, only the return air temperature value is reported to the
multizone controller.
4. The actual default deadband value will depend upon the indoor unit model.
7.

Test Operation

Also see installation manuals attached to the indoor unit and the outdoor
unit.
● Check that wiring work of the indoor unit and the outdoor unit is completed.
● Ensure that covers have been replaced on electrical component boxes for both indoor and outdoor
units prior to restoring power.
● After refrigerant piping, drain piping and electric wiring are completed, clean inside of the indoor unit
and decorative panel.
● Perform the test operation according to following procedure.
● To protect the compressor, apply power to the outdoor unit at least 6 hours prior to test operation.
● Set the remote controller display mode to standard or detailed display mode. Refer to Operation
Manual for the setting method.
Notes for backlight
● The backlight will illuminate for 30 seconds by pressing any button.
● The initial push of the button will only illuminate the backlight. While the backlight is illumi-
nated, the buttons assigned functionality will be available.
7-1
Set the operation mode to cooling by
using the remote controller.
7-2
Press and hold Cancel button for
4 seconds or longer. Service settings
menu is displayed.
7-3
Select Test Operation
settings menu, and press Menu/OK
button. Basic screen returns and Test
Operation is displayed at the button.
English
7- 1
7- 2
in the service
7- 3
<Basic screen>
Cool
Set to
68
F
Return Clean the filter
<Service Settings menu screen>
Service Settings 1/3
Test Operation
Maintenance Contact
Field Settings
Energy Saving Options
Prohibit Function
Min Setpoints Differential
Setting
Press and hold Cancel
button for 4 seconds or
longer during backlight lit.
Press Menu/OK button.
15