Tracer Reintegration (If Installed); Charging The A/C System - Launch VALUE-200 Manual De Instrucciones

Press ENTER to continue.
Set the volume of new oil to be reintegrated, in cc. Press ENTER to confirm. Open the high-
and low-pressure taps (if the A/C system is equipped with a single quick-connect coupling for
high or low pressure, open only the relative tap) of the machine and press START.

TRACER REINTEGRATION (if installed)

This operation can be carried out only following a vacuum procedure and before charging.
Select the assisted procedure when the "ASSISTED PROCEDURE" message flashes on the
LCD, and press ENTER. Select "OIL AND TRACER." When "Oil xx cc" flashes, select
TRACER xx CC and set the volume of tracer to be reintegrated, in cc. Press ENTER to
confirm.
The following message will be displayed:
Press ENTER to continue.
Open the high- and low-pressure taps (in the case of an A/C system with only one pressure
coupling—high or low—open only the relative tap) on the machine and press START.

CHARGING THE A/C SYSTEM

Select the ASSISTED PROCEDURE by pressing ENTER when the "Assisted Procedure"
message flashes on the LCD. Select charging by pressing ENTER when "CHARGING XXXX
G" flashes on the LCD.
Set the quantity of fluid to be reintegrated as explained below.
1. MANUAL OPERATION: set the quantity of refrigerant in grams for the A/C system to be
charged. For example, for 850g press key 8, key 5, and key 0, "Charging 850 g". After
setting the quantity, pressing ENTER to confirm.
On most systems the quantity of fluid to be reintegrated is given on the plate inside the
engine compartment of the vehicle. If you do not know the correct quantity, consult the
relevant manuals.
2. The DATABASE BASIC ( DBB) may be used if installed. Press the ↓ key; the following
will appear on the display:
Find the relevant vehicle code on the "table" provided. Use the numerical keypad to
enter the code. Then press the ENTER key to confirm. The following will appear on the
display:
INSTRUCTIONS MANUAL
ATTENTION
USING PAG OIL OR TRACER IN
HYBRID VEHICLES MAY DAMAGE
THE COMPRESSOR.
USE ONLY SUITABLE OIL WITH A
SEPARATE DEVICE.
ATTENTION
USING PAG OIL OR TRACER IN
HYBRID VEHICLES MAY DAMAGE
THE COMPRESSOR.
USE ONLY SUITABLE OIL WITH A
SEPARATE DEVICE.
INSERT CODE
CAR MODEL
000
Press ENTER to quit
-15-