Mood Light Function; Troubleshooting; Care And Maintenance; Specifications - Beurer WL 90 Manual De Instrucciones

Radio mode
To turn on the radio, proceed as follows:
1. Press the MODE / ENTER button repeatedly until RADIO appears in the LCD Display.
2. Set the radio volume using the +/- buttons.
3. Select a memory preset using the ▲ / ▼ buttons.
4. To search for a station, press and hold the ▲ or ▼ button for three seconds. Briefly press the SET but-
tons ▲ / ▼ to adjust the radio frequency manually in 0.2 MHz increments.
5. To save a radio station to a preset, press the MODE/ENTER button. The corresponding preset number
(e.g. P1) appears in the LCD Display.
Sleep timer
When using the radio or the Bluetooth speaker, you can also enable a sleep timer, which sets the number
of minutes after which the radio or Bluetooth speaker will shut off.
1. In radio mode or Bluetooth speaker mode, press the ▲ / ▼ buttons at the same time.
2. The sleep timer flashes in the LCD Display. Select a desired timer duration using the ALARM button (2,
5, 10, 15, 30, 45, or 60 minutes).
3. To confirm, press the ▲ / ▼ buttons at the same time.
Lamp function
1. Using your hand, tap on the side of the Wake-up Light to make it vibrate lightly. The illuminated display
becomes brighter.
2. Tap on the side of the Wake-up Light again within three seconds. The reading lamp will illuminate.

Mood light function

1. Using your hand, tap on the side of the Wake-up Light to make it vibrate lightly. The illuminated display
becomes brighter.
2. Tap on the side of the Wake-up Light again within three seconds. The white light of the reading lamp
will come on.
3. To activate the mood light with change of color, tap again on the light area.
4. To have colored light permanently display during the color change, tap again on the light area.
5. To deactivate the mood light function, tap again on the light area.

7. Troubleshooting

You can find further information and a list of frequently asked questions (FAQs) about this product at
www.beurer.com.

8. Care and Maintenance

• Clean the device with a dry cloth.
• Do not use any abrasive cleaning products.
• Ensure that no water enters the device; otherwise, do not reuse the device until it has fully dried out.
• Never immerse the device or power cord in water or other liquids.
• Protect the device from knocks, damp, dust, chemicals, large temperature fluctuations, and nearby sources
of heat (ovens, heaters).

9. Specifications

Illumination
Lamp
Light levels
Mood light
Wake-up Light function
Max. approx. 2500 lux (at distance of 6 inches/15 cm)
LED service life: ~50.000 hours
LED non-replaceable
Continuously adjustable via app
Automatic RGB color change; option to set individual color
Off, 2, 5, 10, 15, 20, 30, 45, 60 minutes prior to alarm
7