Fitting The Wheelset (03); Attaching Blow/Vacuum Tube Combi- Nation To Basic Unit (04); Attaching Collection Sack (05); Attaching And Adjusting Carrying Belt (Optional) (06) - AL-KO Energy Flex LBV 4090 Manual De Instrucciones

Start-up

vacuum tube must be in front of each
other.
■
The blow tube hook (02/5) and the vacu-
um tube hook (02/6) must be in front of
each other.
2. Push the blowing and vacuum tubes against
each other until they snap into place (02/a).
4.2

Fitting the wheelset (03)

1. Insert the wheel set (03/1) until it engages in
the bearing (03/2) (03/a).
4.3 Attaching blow/vacuum tube
combination to basic unit (04)
1. Insert the blow/vacuum tube combination
(04/1) up to the stop of the basic unit (04/a)
and hold it in place.
2. Insert first securing bolt (04/2) and screw in
loosely.
3. Insert second securing bolt (04/3) and screw
in loosely.
4. Tighten both securing bolts.
4.4

Attaching collection sack (05)

1. Place the transport handle (05/1) of the col-
lecting sack (05/2) onto the ejection nozzle
(05/3) (05/a).
2. Push the transport handle upwards until the
hook (05/4) on the transport handle and the
hook (05/5) on the basic unit engage.
Note: You can remove the collecting sack af-
ter pressing the release catch (05/6).
3. Hook the two eyes of the bag into the hooks
(05/7) of the blow tube.
4.5 Attaching and adjusting carrying belt
(optional) (06)
1. Attaching the carrying belt:
■
Align the belt (06/1) on the appliance so
that the buckle (06/2) is in front of the op-
erator and the shoulder pad (06/3) is on
the operator's shoulder.
■
Hook the snap hooks (06/4) of the carry-
ing belt into the eyes (06/5) on the basic
unit.
2. Adjust the length of the carrying belt:
■
Hang the entire appliance on the shoul-
der with the carrying belt. The buckle
must be in front of the operator and the
shoulder pad on the shoulder.
■
Move the buckle until the support wheels
touch the ground.
442490_a
4.6

Adjusting front handle (07)

1. Pull out (07/a) drawbar eye (07/1).
2. Turn the front handle (07/2) to the desired
position (07/b).
5 START-UP
5.1

Charging the rechargeable battery (08)

CAUTION!
Danger of fire during charging!
Due to heating of the charger, there is a
danger of fire if it is placed on an inflam-
mable surface and is not adequately
ventilated.
■
Always use the charger on a non-in-
flammable surface or in a non-com-
bustible environment.
■
If available: Keep the ventilation
slots free.
NOTE
The rechargeable battery and the
charging unit are not included.
The rechargeable battery is partially charged.
Fully charge the rechargeable battery before us-
ing it for the first time. The rechargeable battery
can be charged in any charge status. Interrupting
charging does not damage the rechargeable bat-
tery.
NOTE
For detailed information, heed the sepa-
rate operating instructions for the re-
chargeable battery and for the charging
unit.
See:
■
Operating Instructions 441630 "Li-Ion re-
chargeable battery B150 Li (B05-3640), B200
Li (B05-3650)"
■
Operating Instructions 441633 "Charging unit
C130 Li for batteries B150 Li (B05-3640),
B200 Li (B05-3650)"
39