Olympus PT-E Serie Manual De Instrucciones página 15

5. Maintenance
For safe use of this product, always perform maintenance after each diving session.
For details, refer to "Handling After Shooting" and "Maintaining the Waterproof Function" in the PT-E
series case instruction manual. Apply the same procedures to this product.
1 After shooting, remove the inserted camera
and lens, then re-seal the empty case and
immerse it in tap water to remove any salt as
soon as possible.
3 Insert the O-ring remover between the O-ring
and O-ring groove so that the tip of the O-ring
remover slides under the O-ring (take care not
to damage the groove with the tip of the O-ring
remover). When the O-ring is raised, pinch it
with your fingers and separate it from the
case.
5 If any foreign matter is attached to the O-ring
grooves, remove it using a clean, lint-free
cloth or cotton swab. Also remove any foreign
matter from the O-ring contact surfaces and
from the port mount thread on the PT-E series
case.
2 After making sure that the PT-E series case is
completely dry, dismount this product from the
case.
4 Remove any dust that you can see from the
O-ring, and then pinch the O-ring with your
fingers and rub it along its length to check for
foreign objects such as sand, damage and
cracks.
6 After removing foreign matter, apply the
provided grease to the O-rings and fit them
into the O-ring grooves. To apply grease to
each O-ring, squeeze a drop of grease about
the size of a grain onto your finger and lightly
rub the entire circumference of the O-ring to
spread the grease thinly and evenly.
En
EN 6