Connection To A Pool Cover - POOL Autosalt Manual De Usario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6
PH PROBE AND INJECTION SYSTEM
1/ Connect the suction strainer to the pH pump with a part of the supplied pipe. Respect the sense of arrows
representing on the top of the pH pump.
2/ Connect the exit of the Ph pump to the injection connector with the rest of the supplied pipe and screw it
under the accessories holder.
3/ Remove the cap in place on the accessories holder. Preserve it for a future use.
4/ Remove the rubber protection at the end of the pH probe. Screw the probe on the top of the accessories
holder (Make sure that it is not in abutment with the waterworks).
5/ Connect the cable of the pH probe (BNC jack) under the controller box.
1/
7
CONNECTION TO A POOL COVER (cable in option : ref OPT04POO0001)
1/ In the controller of the pool cover, locate the limit switch (a dry contact, without any connection). Some
pool cover manufacturers specifically identify this switch for salt chlorinator control.
2/ Connect with an electric cable (in option : ref OPT04POO0001) the dry switch of the pool cover in the
connector female : unsettle this one and connect the threads on the 2 opposite borders (noted 1 and 2).
3/ Plug the connector female on the male connector.
4/ Connect salt/temperature sensor to the DIN jack female.
5/ Connect the DIN male jack on the base of the salt chlorinator.
AUTOSALT®/POOLSQUAD®/POOLSQUAD® AMPERO/PRO - PAPI004082 – FR/EN/ES/DE - Rev.03.16
5/
4/
3/
2/
Pool cover control box
Dry contact
Salt/Temperature
Sensor
7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

PoolsquadPoolsquad amperoPoolsquad pro

Tabla de contenido