Festool SYSROCK BR 10 DAB+ Manual De Instrucciones página 24

GB
BR 10 DAB+
During the scanning process, as new
stations are detected, the station
counter will increase and stations
will be added to the list. The display
shows a bar graph indicating the
progress of the scan.
When the scanning is completed, the
first station (in numeric-alpha order
0...9...A...Z) will be selected.
If the station list is still empty after
the scan, your radio will display <No
stations found>.
If no signals are found, it may be nec-
essary to relocate your radio to a po-
sition giving better reception.
Selecting a station - DAB

Press the Power button [1-6] to
switch on your radio.

Press the source button [j] until
the DAB mode is selected. The dis-
play will show the name of the ra-
dio station currently selected.

Press the Tuning control [i], [h] to
scroll through the list of available
stations.

Press the Select button [g] to se-
lect the station. The display may
show <Connecting...> while your
radio finds the new station.

Adjust the Volume control [a], [k]
to the required setting.
24

NOTE: If after selecting a sta-
tion, the station is not found it
may be necessary to relocate
your radio to a position giving
better reception.
Secondary service - DAB
Certain radio stations have one or
more secondary services associated
with them. If a station has a second-
ary service associated with it, the dis-
play will show this information under
the station name.
Most secondary services do not
broadcast continually and if the se-
lected service is not available, the ra-
dio will re-tune to the associated pri-
mary service.
Display mode - DAB
Your radio has a range of display op-
tions when in DAB mode:

Press and hold the Info button [j]
more than 2 seconds until <DAB In-
fo> is shown on the display and
then press and release the Tuning
control [i], [h] to cycle through the
various modes.