Installing Shaft And Gearcase; Attaching Strap; Before Operation; Chain Oil - Maruyama TPP27 Manual Del Propietario U Operador

Installing Shaft and Gearcase

Attach the shaft assembly to the Pruner gearcase
assembly.
Note: Align the locating hole and install the locating
screw through the side of the gearcase. Then
tighten the clamping screw.
LOCATING HOLE
2
1

Attaching Strap

Snap the strap hook into the ring on the drive shaft. To
detach the strap quickly from the Pruner, pull upward
on the red band.
Red Band
Pull
Hook
Ring
4
1. CLAMPING SCREW
2. LOCATING SCREW
3. GEARCASE
3
4. SHAFT ASSEMBLY
Strap

Before operation

Chain oil

1) Adding oil
1. Remove the oil tank cap and pour the chain oil
(SAE #10W-30) into the oil tank.
2. Once the oil has been poured into the oil tank,
tighten the oil tank cap to securely close the tank.
• Ensure that the guide bar and saw
chain are installed on the pruner before
verifying the discharging rate of the
chain oil. The rotator will be exposed
and therefore dangerous if the guide
bar and the saw chain are not installed
on the pruner.
The regulating screw has three positions, Minimum,
Intermediate and Maximum, only.
The regulating screw is set to Intermediate at the time
of shipping. It is recommended that the product be used
with this setting for ordinary use.
• Increase the discharging rate when cutting hard
branches or branches with a lot of resin (pitch), or
when the viscosity of the oil is high during winter.
1. Insert a minus screw driver into the regulating
screw at the bottom of the main unit.
— US-14 —
Locating Hole
1
2
4
3
1. Clamping Screw
2. Locating Screw
3. Gearcase
4. Shaft Assembly
Oil tank cap
DANGER
Oil tank