Installing Shaft And Gearcase; Before Operation; Chain Oil - Maruyama P23-10 Manual Del Operador

Saw chain lightly touches the guide bar
Regulating screw
Lift up leading edge of guide bar
Lifts up 3 to 4 mm when lifted lightly by fingers

Installing Shaft and Gearcase

Locating Hole
Attach the shaft assembly to the Pruner gearcase
1
2
assembly.
Lifts up 3 to 4 mm when lifted lightly by fingers
Note:
Align the locating holes and install the locating screw
through the side of the gearcase. Then tighten the
clamping screws.
Locating Hole
1
2
Tighten
Loosen
4
3
1. Clamping Screw
2. Locating Screw
3. Gearcase
4. Shaft Assembly
4
Oil tank cap
3
1. Clamping Screw
2. Locating Screw
3. Gearcase
4. Shaft Assembly
Oil tank
Oil tank cap
Oil tank
Lifts up 3 to 4 mm when lifted lightly by fingers
1

Before operation

Chain oil

1) Adding oil
1. Remove the oil tank cap and pour the chain oil
(SAE #10W-30) into the oil tank.
2. Once the oil has been poured into the oil tank,
tighten the oil tank cap to securely close the tank.
• Ensure that the guide bar and saw chain
are installed on the pr uner before
verifying the discharging rate of the
chain oil. The rotator will be exposed
and therefore dangerous if the guide bar
and the saw chain are not installed on
the pruner.
− US-14 −
Nut
Locating Hole
2
4
3
1. Clamping Screw
2. Locating Screw
3. Gearcase
4. Shaft Assembly
Oil tank cap
Oil tank
DANGER