Assembly; Assembling Engine And Drive Shaft Assembly; Loop Handle Installation - Maruyama E30S Manual Del Propietario U Operador

Assembly

Assembling Engine and Drive
Shaft Assembly
The drive shaft, clutch drum housing and gearcase are
assembled. Attach the clutch drum housing to the
engine using the four M5 x 20 screws supplied with the
unit.
Engine

Loop Handle Installation

The loop handle kit contains a package of four screws
nuts and the bottom clamp for the loop handle.
Screw (4)
Nut (4)
M5 x 20 Screw (4)
Shaft
Clutch Drum Housing
Loop Handle
Rubber Sleeve
Bottom Clamp
— US-12 —
1. Place the loop handle and the bottom clamp
approximately 9 inches (22.8 cm) from the end of
the stop switch/throttle trigger assembly for an
initial handle position.
2. Install the four screws and nuts. Leave the screws
finger-tight.
3. Reposition the loop handle up or down the drive
shaft to the most comfortable position, but no
closer than 9 inches (22.8 cm) from the end of the
stop switch.
4. Tighten the screws and nuts.