Zodiac MX 8 Manual Del Propietário página 10

Page 10
ENGLISH
Cleaner Vacuum Modes
The MX8 Pool Cleaner is designed to operate with two vacuum options:
1. Small debris cleaning mode (factory setting): For vacuuming smaller and heavy debris, such as sand, silt
and small stones. The pool cleaner is sent from the factory in this mode.
2. Large debris cleaning mode: (Figure 11) For vacuuming large debris, such as leaves. It is recommended
that you return the cleaner to small debris factory setting after large debris cleaning is complete (Figure 12).
To avoid serious injury, make sure that the cleaner is disconnected from the hose and the suction pump used for the cleaner is turned
off prior to starting this operation.
Convert the pool cleaner to the large
debris cleaning mode:
1. Grasp the yellow inlet adapter and insert a
finger into the adapter hole.
2. Lift up the rear edge of the inlet adapter and
then pull it out of the vacuum inlet.
Convert the cleaner back to the small
debris cleaning mode:
- Place the yellow inlet adapter in the vacuum
inlet of the pool cleaner. Push down on the
yellow inlet adapter until both the front and rear
edges click into place.
|
Zodiac MX8 Pool Cleaner
®
™
WARNING
Front of cleaner
Figure 12
Owner's Manual
Front of cleaner
Rear edge
Inlet adaptor
Rear edge
Inlet adaptor
Figure 11
Front edge
Cleaner with the
inlet removed
Fron
Cleaner
inlet rem