Equipment (Ppe) To Be Used During All Of The Machine's Operating Phases - GASPARDO PINOCCHIO ATTILA - ARTIGLIO Manual De Operación

2.1 SUMMARY OF PERSONAL PROTECTION EQUIPMENT
(PPE) TO BE USED DURING ALL OF THE MACHINE'S
OPERATING PHASES
Phase
Transportation
Movement
Installation and setting in
Alignment, adjustment,
dragging (hauling)
Custom use
Control
Lubrication
Maintenance
Cleaning
Shut down
Demounting
Demolition
Disposal
Explanations:
The following table summarises the PPEs (Personal Protection
Equipment) to be used during the various operating phases of the
machine (for each phase the use and/or placing at the worker's
disposal of the PPEs is mandatory).
Life-span of the
equipment
Transport
Moving
Fitting
Adjust, checking
Use
Control
Oiling
Incorect use
Maintenance
Clining
Shut-down
Remove
Demolition
Disposal
cod. R19502010
USE AND MAINTENANCE
Overalls
DPI ENVISAGED
DPI IN USE OR FOR USE IN CASE OF NEED
DPI CONTINGENCIES
Description
Provides for the transfer of the equipment from one place
to another by means of a suitable vehicle
Provides for the transfer of the equipment from and into
the transporting vehicle for movements not including
road transport
Provides for all the assembling operations that
preliminarily prepare the equipment for set up
Provides for the adjustment, setting up and calibration of
all those devices that need to be adapted to the operating
conditions normally provided for and which cannot be
securely fixed during assembling operations
Use for which the equipment is destined in conformity with
the instructions provided by the manufacturer or
considered usual on the basis of its design, construction
and function
Consists of the checking of the equipment's functions
Provides for the lubrication or greasing of the mobile
parts such as bearing, slides, shafts etc.
Use resulting from involuntary negligence and not from a
deliberate intention to use the equipment improperly
Consists of the periodical checking of the equipment that
are subject to wear or that may require replacing
Consists of the removal of dust and cultivation residues
that could jeopardise the performance and use of the
equipment, as well as the health/safety of the operator
Provides for the disassembling of the equipment from the
tractor after work has been completed
Consists of the complete or partial disassembling of the
equipment, so as to allow possible recycling or segregated
waste collection of the components according to the
provisions laid down by the laws currently in force
Consists of the definitive removal of all the parts of the
equipment resulting from the dismantling operation
Operation that consists of the dismantling of products/
substances contained in the equipment
Shoes Gloves
The PPEs used must be CE marked and respond to EEC Directive
89/686, transposed in Italian low with Legislative Decree D. Lgs.
475/92 and subsequent revisions.
Responsibility for identifying and selecting the type and category
of PPE.
The following table lists the machine life phases.
ENGLISH
Glasses
Mask
Example and mentions
e.g.: use of vehicle on road, rails,
etc.
e.g.: use of bridge cranes or special
cranes, forklift trucks, etc.
e.g.: mechanical assemblies,
auxiliary circuits, etc.
e.g.: adjustment of mechanical
parts, relative alignments, etc.
e.g.: the verification of the correct
functioning of the safety devices,
etc.
e.g.: the use of the equipment
without complying with the
provisions of the manual, the
operators fail to use the DPI, etc.
e.g.: anchor, bolts, cushions/pads-
e.g.: removal of earth from the hook-
up points of the anchors and from
the rear rollers
These parts shall be disposed of,
scrupulously following the provisions
laid down in the legislation in force
33