Symbols On The Product; Product-Dependent Symbols; Product Information; Declaration Of Conformity - Hilti AG 450-7S Manual De Instrucciones

Ocultar thumbs Ver también para AG 450-7S:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1.3

Symbols on the product

1.3.1

Product-dependent symbols

The following symbols are used on the product:
Wear protective goggles
Revolutions per minute
Revolutions per minute
Rated speed
Diameter
Protection class II (double-insulated)
1.4

Product information

products are designed for professional users and only trained, authorized personnel are
permitted to operate, service and maintain the products. This personnel must be specifically informed about
the possible hazards. The product and its ancillary equipment can present hazards if used incorrectly by
untrained personnel or if used not in accordance with the intended use.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to state the product details when
contacting Hilti Service or your local Hilti organization to inquire about the product.
Product information → page 2
Product information
Angle grinder
Generation
Serial no.
1.5

Declaration of conformity

We declare, on our sole responsibility, that the product described here complies with the applicable directives
and standards. A copy of the declaration issued by the certification department can be found at the end of
this documentation.
The technical documentation is filed here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistrasse 6 | 86916 Kaufering, Germany
2
Safety
2.1

General power tool safety warnings

WARNING
Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Work area safety
▶ Keep work area clean and well lit. Cluttered or dark areas invite accidents.
▶ Do not operate power tools in explosive atmospheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks which may ignite the dust or fumes.
▶ Keep children and bystanders away while operating a power tool. Distractions can cause you to lose
control.
2
English
Printed: 23.07.2018 | Doc-Nr: PUB / 5169271 / 000 / 03
AG 450-7 (S/D)
03
2075440
*2075440*

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ag 450-7d

Tabla de contenido