Technical Data; Before Use - Hilti AG 450-7S Manual De Instrucciones

The maximum grinding disc thickness is 1/4" and the maximum cutting disc thickness is 1/8".
WARNING! When cutting or slitting with cutting discs, always use the standard guard with additional
cover plate.
Discs
Abrasive cutting disc
Diamond cutting disc
Abrasive grinding disc
Wire brushes
Suitability of discs for the equipment used
Item Equipment
A Guard
B Front cover (in combination
with A)
C Side handle
D Clamping nut (not for use
with accessories with inte-
grated thread)
E Clamping flange (not for
use with accessories with
integrated thread)
F Type 27 guard
5

Technical data

If the product is powered by a generator or transformer, the generator or transformer's power output must
be at least twice the rated input power shown on the rating plate of the product. The operating voltage of
the transformer or generator must always be within +5 % and -15 % of the rated voltage of the product.
The information given applies for a rated voltage of 120 V. Actual figures can vary for country-specific
versions and if the voltage supply differs. For rated voltage, frequency, input power and rated current, refer
to the rating plate.
Rated current input
Rated speed
Rated frequency
Weight
Maximum disc diameter
Drive spindle thread
Thread length
6

Before use

CAUTION
Risk of injury. The accessory tool may be hot or have sharp edges.
▶ Wear protective gloves when fitting, removing or adjusting the accessory tool or other parts and when
troubleshooting.
6.1 Fitting the side handle
▶ Screw the side handle into one of the threaded bushings provided.
8 English
Printed: 23.07.2018 | Doc-Nr: PUB / 5169271 / 000 / 03
Application Designation
Cutting, slitting AC­D
Cutting, slitting DC­D, DC­TP
Rough grinding AG­D, AF­D, AN­D
Wire brushes 3CS, 4CS, 3SS, 4SS
AC­D AG-D AF-D
X X X
X — —
X X X
X X X
X X X
— — —
AG 450-7 (S/D)
7 A
11,500 /min
60 Hz
4.4 lb
(2.0 kg)
4.5 in
5/8"-11
3 3/8"
Material
Metal
mineral
Metal
Metal
AN-D DC­D 3CS/3SS/
4CS/4SS
X X X
— X —
X X X
X X —
X X —
— X —
2075440
AG-D
type 27
—
—
X
—
—
X
*2075440*