Battery; Jump Starting; Charging Battery - Textron JACOBSEN Groom Master II Manual De Piezas Y Mantenimiento

4.8

BATTERY ________________________________________________________________

Make absolutely certain the ignition switch is OFF and the
key has been removed before servicing the battery.
CAUTION
!
Always use insulated tools, wear protective glasses or
goggles, and protective clothing when working with
batteries. You must read and obey all battery
manufacturer's instructions.
Tighten cables securely to battery terminals and apply a
light coat of silicone dielectric grease to terminals and cable
ends to prevent corrosion. Keep vent caps and terminal
covers in place.
Always disconnect battery cables from battery before
performing any welding operation on the groomer.
4.9

JUMP STARTING __________________________________________________________

Before attempting to "jump start" the groomer, check the
condition of the discharged battery. Section 4.8
WARNING
!
Batteries generate explosive hydrogen gas. To reduce
the chance of an explosion, avoid creating sparks near
battery. Always connect the negative jumper cable to the
frame of the groomer with the discharged battery, away
from the battery.

4.10 CHARGING BATTERY _____________________________________________________

WARNING
!
Charge battery in a well ventilated area. Batteries
generate explosive gases. To prevent an explosion,
keep any device that may create sparks or flames away
from the battery.
To prevent injury, stand away from battery when the
charger is turned on. A damaged battery could explode.
1. Refer to Section 4.8. Read the Battery and Charger's
manual for specific instructions.
2. Whenever possible, remove the battery from the
groomer before charging. If battery is not sealed, check
that the electrolyte covers the plates in all the cells.
3. Make sure the charger is OFF. Then connect the
charger to the battery terminals as specified in the
charger's manual.
MAINTENANCE
Check the electrolyte level every 100 hours. Keep the cable
ends, battery and battery posts clean.
Verify battery polarity before connecting or disconnecting
the battery cables.
1. When installing the battery, always assemble the RED,
positive (+) battery cable first, and the ground, BLACK,
negative (-) cable last.
2. When removing the battery, always remove the
ground, BLACK, negative (-) cable first, and the RED,
positive (+) cable last.
3. Make sure battery is properly installed and secured to
the battery tray.
When connecting jumper cables:
1. Stop the engine on the vehicle with a good battery.
2. Connect RED jumper cable to the positive (+) terminal
on the good battery and to the positive (+) terminal on
the "discharged" battery.
3. Connect the BLACK jumper cable from the negative (-
) terminal on the good battery to the frame of the
groomer with the discharged battery.
After cables have been connected, start the engine on the
vehicle with the good battery then start the groomer.
4. Always turn the charger OFF before disconnecting
charger from the battery terminals.
4
en-17