Publicidad
Idiomas disponibles
Idiomas disponibles
OBJ_DOKU-0000000395-002.fm Page 13 Wednesday, April 27, 2011 3:19 PM
Mounting or replacing a sanding sheet
(figure 6).
The sanding pad (round or triangle-poli-
gon) or the carbide rasp can be fastened
on the drive shaft at the suitable position. An
adapter is required for working with the sand-
ing pad.
Align the sanding sheet and press it manually
against the sanding pad.
Firmly press the power tool with the sanding
sheet against a flat surface and briefly switch
the power tool on. This provides for good
adhesion and prevents premature wear.
When only one tip or corner of the sanding
sheet is worn, it can be removed again and
reattached turned by 120°.
en
13
Publicidad
