Publicidad
Idiomas disponibles
Idiomas disponibles
OBJ_BUCH-0000000014-002.book Page 16 Tuesday, April 19, 2011 4:31 PM
en
16
Notes on sanding.
Typical application: Dry sanding of wood and
painted surfaces.
Work with the entire surface of the sanding
plate, not only with the tip. Select a high oscil-
lating frequency. Sand with continuous motion
applying moderate pressure. Applying high
pressure does not increase the rate of
removal, it only wears off the sanding sheet
faster.
Handling the battery.
Operate and charge the battery only within
the battery operating-temperature range of
0 °C – 45 °C (32 °F – 113 °F). At the beginning
of the charging procedure, the battery tem-
perature must be within the battery operat-
ing-temperature range.
Battery charge-control indicator
(figure 10).
Press the button to activate the LED indica-
tion.
LED indicator Meaning
1 – 4 green
Percent-
LED
age of
charge
condition
Continuous
Battery is
red light
almost
empty
Red flashing
Battery is
light
not ready
for opera-
tion
The real percentage of the battery charge
condition is only indicated when the power
tool motor is stopped.
The electronics automatically switch off the
motor prior to the battery being deep dis-
charged.
Notes on sawing.
Typical application: Sawing thin steel sheet,
wood and plastic parts.
Select a high oscillating frequency.
Round saw blades can be clamped offset
again, to allow for uniform wearing off.
When sawing and plunging, provide for good
removal of chippings by applying moderate
pendular motion.
Notes on scraping.
Typical application: Scraping off old coatings
or adhesive, removal of glued carpet, e. g., on
steps or other small/mid-sized surfaces.
Select a moderate to high oscillating fre-
quency.
Fig. 10
Activity
Operation
Charge battery
Bring the battery
into the battery
operating-tem-
perature range,
then charge
Battery-Unlocking button
Pushbutton
Publicidad
