Publicidad
Idiomas disponibles
Idiomas disponibles
OBJ_BUCH-0000000014-002.book Page 14 Tuesday, April 19, 2011 4:31 PM
en
14
Cutter blades for automobile glazing
applications (figure 7).
Guide the straight, bent or offset cutter
blades at a right angle to the window flange;
blade A – D.
For U-shaped cutter blades, pay attention that
the traverse of the cutter blade is led parallel
to the window pane of the vehicle; blade C.
The scraper knife is used for cutting back
bond remainders on the window flange or the
pane. Before re-bonding the vehicle window,
cut back the remaining bead to a height of
approx. 2 mm; blade E – F.
Cutter blades marked with a symbol may only
be operated as indicated.
Publicidad
