Leg Set Assembly - LEMAN TAB085 Manual De Instrucciones

VARIABLE SPEED WOOD LATHE

Leg Set Assembly

Attach one front leg and one back leg

(1) to the outside edges of the top
plate (2) using carriage bolts (3),
washers (4) and nuts (5). The top
plate (2) should fit inside the legs (1).
Do not tighten nuts at this time.
Repeat this

remaining legs and top plate.
Attach the long stretchers (6) to the

legs using carriage bolts, washers and
nuts.
Attach the short stretchers (7) on the

ends of the legs in the same fashion.
Place the leg stand on a level surface and tighten all nuts securely using a

14mm wrench.
Installing the lathe on the leg set
CAUTION: The lathe is heavy, use assistance for lifting.
Place the lathe unit on the leg set.

Position the headstock (2) assembly

over the top plate and align the holes
of the lathe bed (3) with the holes in
the top plate (4).
Align the tailstock assembly bolt holes

with the top plate holes.
Install the Allen bolts (5) into all of the

mounting holes and through the top
plates.
Install a washer (6) and nut (7) onto

each bolt and tighten securely with a wrench and the supplied Allen keys.
Verify that all nuts and bolts are securely fastened.

Assembly, Continued
procedure for the
EN
9