Headlock Handle; Spurs - LEMAN TAB085 Manual De Instrucciones

VARIABLE SPEED WOOD LATHE

Headlock Handle

Locate and assemble the head locking

handle (1), spring (2) and Allen bolt (3)
as shown.
Thread the head lock assembly into the

head locking clamp and tighten.
Note: Spring loaded handles
The spring-loaded handles on the lathe
are designed to minimize interference with
other lathe parts or the workpiece. To operate
these handles, push the handle in and rotate
clockwise to tighten. Releasing the handle will
disengage the threaded shaft allowing you to reposition the handle so that it is
out of the way.

Spurs

Remove the faceplate (if factory

installed) (1) from the headstock using
the 2 wrenches (2) provided and set
aside.
Insert the headstock spur (3) into the

spindle hole.
Install the tailstock live center into the

tailstock hole.
Removal of spurs
To remove either the headstock spur or

the tailstock live center insert the push
rod (5) through the back access holes of
the headstock and tailstock.
Remove the rod and store it for future

use.
Assembly, Continued
EN
10