Tailstock; Articulated Tool Rest; Important - LEMAN TAB085 Manual De Instrucciones

VARIABLE SPEED WOOD LATHE

Tailstock

Move the tailstock (1) by loosening

the tailstock lock lever (2) and
sliding the tailstock assembly to the
desired position on the lathe bed.
Securely lock the tailstock into
position by tightening the lock lever.
The tailstock spindle (3) can

extend up to 2 1/2" from the
tailstock housing. You can move
the tailstock spindle by loosening
the spindle lock lever (4) and then rotating the spindle hand wheel (5).
Be sure that lock levers (4) and (2) are secure before operating the lathe.

The tailstock spindle is hollow and can be accessed from the hand wheel

end. Use the push-out rod to remove the Morse Taper tailstock spindle.

Articulated Tool Rest

The articulated tool rest (1) may be

used with or without the extension
arm (2).
To move the tool rest base (3)

loosen the lock lever (4) and slide
the tool rest base left or right along
the lathe bed or it may be moved
forward or backwards.
When using the tool rest extension

arm you can loosen lock levers (5)
and (6) to make any necessary adjustments.
Be certain to tighten all tool rest locking levers before turning on the lathe.

The articulated tool rest may also be repositioned onto the extension bed

for use on outboard turnings.
IMPORTANT: Make sure that the tool rest is adjusted to be as close to the
workpiece as possible. Rotate the workpiece by hand to check the
clearance before turning the lathe on.
Operation, Continued
EN
13