WAGNER PAINTEATER Manual Del Propietário página 6

WARNING! Read all safety warnings and all instructions. Failure to follow the
warnings and instructions may result in electric shock, fire and/or serious injury.
• Wear personal protective equipment. depending on application, use face shield, safety
goggles or safety glasses. As appropriate, wear dust mask, hearing protectors, gloves
and workshop apron capable of stopping small abrasive or workpiece fragments. The
eye protection must be capable of stopping flying debris generated by various operations. The
dust mask or respirator must be capable of filtrating particles generated by your operation.
Prolonged exposure to high intensity noise may cause hearing loss.
Keep bystanders a safe distance away from work area. Anyone entering the work
•
area must wear personal protective equipment. Fragments of workpiece or of a broken
accessory may fly away and cause injury beyond immediate are of operation.
• hold power tool by insulated gripping surfaces only, when performing an operation
where the cutting accessory may contact hidden wiring or its own cord. Cutting
accessory contacting a "live" wire may make exposed metal parts of the power tool "live" and
shock the operator.
• Position the cord clear of the spinning accessory. If you lose control, the cord may be cut
or snagged and your hand or arm may be pulled into the spinning accessory.
Never lay the power tool down until the accessory has come to a complete stop. The
•
spinning accessory may grab the surface and pull the power tool out of your control.
• do not run the power tool while carrying it at your side. Accidental contact with the
spinning accessory could snag your clothing, pulling the accessory into your body.
Regularly clean the power tool's air vents. The motor's fan will draw the dust inside the
•
housing and excessive accumulation of the material or powdered metal may cause electrical
hazards.
do not operate the power tool near flammable materials. Sparks could ignite these
•
materials.
• do not use accessories that require liquid coolants. Using water or other liquid coolants
may result in electrocution or shock.
Maintain a firm grip on the power tool and position your body and arm to allow you
•
to resist kickback forces. Always use auxiliary handle, if provided, for maximum
control over kickback or torque reaction during start-up. The operator can control torque
reactions or kickback forces, if proper precautions are taken.
Never place your hand near the rotating accessory. Accessory may kickback over your
•
hand.
• do not position your body in the area where power tool will move if kickback occurs.
Kickback will propel the tool in direction opposite to the wheel's movement at the point of
snagging.
use special care when working corners, sharp edges, etc. Avoid bouncing and
•
snagging the accessory. Corners, sharp edges or bouncing have a tendency to snag the
rotating accessory and cause loss of control or kickback.
do not attach a saw chain woodcarving blade or toothed saw blade. Such blades create
•
frequent kickback and loss of control.
• do not use excessively oversized sanding discs. This tool is designed to use only the
sanding disc sold with the tool, or replacement purchased from the manufacturer or
manufacturer representative. do not purchase or install any type of sanding disc that
uses paper, or any other accessory not purchased directly from the manufacturer or
manufacturers representative.
6
English
Save all warnings and instructions for future reference.