Lenco SCD-300 Manual Del Usuario página 6

POWER SUPPLY
 BATTERY OPERATION
1. Remove the battery compartment cover gently.
2. Install 6 x 'C' size batteries (UM-2 or equivalent) while observing the correct polarities.
3. Replace the battery compartment cover.
NOTE:
The AC/DC adapter must be detached from the DC IN jack of the player for battery

operation.
Leaking batteries may damage the battery cabinet and the player as a whole, so they should

be removed from the cabinet when becoming flat or when the player is not to be played on
batteries for some time.
 DC INPUT OPERATION
Plug the supplied adapter to the DC IN jack on the unit and the main power.
NOTE: If not any audio signal inputs to the unit in about one hour, the unit will enter to standby
mode automatically (except at FM radio mode).
FM RADIO
TUNING THE FM RADIO
1. The standby indicator will light once connect the main unit to the main power. Press the
ON/STANDBY button to turn the unit on (the standby indicator will be off).
2. Press the SOURCE button repeatedly to switch the unit to radio mode if necessary.
3. To launch the auto-searching, press and hold the SKIP/SEARCH DOWN button or SKIP/SEARCH
UP button several seconds and then release it.
4. Press the SKIP/SEARCH DOWN button or SKIP/SEARCH UP button to tune the radio stations
manually.
5. Adjust the volume level to a comfortable listening level via pressing the VOLUME +/- buttons.
6. Press the ON/STANDBY button to turn off the unit.
NOTE:
The FM telescopic antenna is directional. When you are receiving an FM broadcast, fully extend

the telescopic antenna and rotate it for the best reception.
STORING YOUR FAVORITE RADIO STATION
1. Tune to your favorite station first; press the MEM/MODE/PROG button for storing the current
station until memory cell number flashes on the screen.
2. Use the STOP/CH- button or the PLAY/PAUSE/CH+ button to select the corresponding memory
cell among P01-P20.
3. Confirm your selection by pressing the MEM/MODE/PROG button.
4. During radio playback, press the STOP/CH- button or the PLAY/PAUSE/CH+ button repeatedly to
recall the preset stations.
5