Operating Your Radio - Fm - Festool SYSROCK BR 10 DAB+ Manual De Instrucciones

English
► To carry out a full scan of the entire
DAB Band III frequencies press and
hold the Tuning control [h] more
than 2 seconds. As new stations are
found, the station counter on the
display will increase and stations
will be added to the list. The bar
graph indicates the progress of the
scan.
Clear stations (Prune function)- DAB
If you move to a different part of the
country, some of the stations which
were listed may no longer be available.
Also from time to time, some DAB serv­
ices may stop broadcasting, or may
change location or frequency. Stations
which cannot be found, or which have
not been received for a very long time
are shown in the station list with a
question mark. The Prune stations
function (Clear) [i] will delete the
marked DAB stations from your station
list.
► Press the Power button [1-6] to
switch on your radio.
► Press the source button [j] until the
DAB mode is selected.
► Press and hold Clear button [i]
more than 2 seconds until <DAB> is
shown on the display.
► Press and release the Tuning con­
trol [i], [h] to select <Clear> or
<Back>. If you do not wish to enter
the Prune function select <Back>,
and press and release the Select
button [g] to confirm the setting.
► To enter the Prune function select
<Clear>, and press and release the
Select button [g] to enter the set­
ting. Press and release the Tuning
control [i], [h] to select <YES> or
<NO>. To activate the Prune function
select <YES> and press the Select
20
button [g] to confirm the setting. If
you do not wish to prune stations,
select <NO> and then press Select
button [g] to confirm the setting.
NOTE: If you have moved your ra­
dio to a different part of the coun­
try you should also carry out a
search for new stations (please
see the section 'Finding new sta­
tions').
5.7

Operating your radio - FM

► Straighten up the antenna [1-3].
Press the source button [j]
►
until the FM mode is selected.
FM auto-tune
► Press and hold (~2 sec.) the Tuning
control [i], [h] to carry out an auto-
tune.
Your radio will stop scanning when it
finds a station of sufficient strength.
The display will show the frequency of
the signal found. If the signal is strong
enough and there is RDS data present,
the radio may display the station name,
radio text and clock time.
Finding other stations
► Press the Tuning control [i], [h] as
before.
When the end of the waveband is
reached, your radio will restart tuning
from the opposite end of the waveband.
If you find that FM reception is
poor, try repositioning the anten­
na.
Manual tuning -FM
► Press the Tuning control [i], [h] to
tune to a station.
The frequency will change in steps of
0.1 MHz.