Release the locking device (11) on the feed gear and use the hand wheel (4) to turn the drill
downward to the desired drill depth.
Switch off the motor and crank back until the drill bit is completely visible.
In case of seizure, start up the drill motor again at low speed using cooling water
and withdraw the core bit!
In case of need, repeat the process or turn the core bit using the SW 41 flat
wrench. Please note: Switch off the RCD switch
4
Care and Maintenance
Upkeep, servicing and maintenance work must only be carried out when the system is at a
standstill.
The best maintenance measures involve the daily removal of sludge, dust and dirt. Special at-
tention must be paid to the guide column and sliding guide as well as to the gear rack and the
feed bevel. The spindle should be oiled lightly each time it is cleaned.
The sliding guides should be checked for play at regular intervals and re-adjusted if necessary.
Do not grease the drill column and gear rack as the grease takes effect as a grinding
paste together with the adherent dirt and increases wear.
Clean the adjusting screws on the base plate every day and keep them free-moving.
Important! All maintenance, overhauling and repair work must only be carried out by trained
specialised staff.
5
Accessories
Accessory Name
Strut head
Quick clamp column
Fastening concrete set
Fastening brickwork set
RODIA DRY CLEANER 1200
RODIA CLEANER 1400
Drill bits
6
Customer service
The ROTHENBERGER service locations are available to help you (see listing in catalog or on-
line) and replacement parts and service are also available through these same service locations.
Order your accessories and spare parts from your specialist retailer or using our service-after-
sales hotline:
Phone:
+ 49 (0) 61 95 / 800 – 8200
Fax:
+ 49 (0) 61 95 / 800 – 7491
Email:
service@rothenberger.com
www.rothenberger.com
14
ROTHENBERGER Part Number
No. FF50874
No. FF35015
No. FF35120
No. FF35121
No. FF35148
No. FF35210
www.rothenberger.com
ENGLISH