Care And Maintenance; Accessories; Disposal - Rothenberger RODIACUT 170 PRO-D Instrucciones De Uso

 Insert the feed unit with the drill motor into the drill column (5) and use the locking device
(7) to fasten.
 Proceed in the reverse order in order to remove
Setting the magnetic depth stop (13):
 Insert the magnetic depth stop (13) into the toothing of the drill column to the desired drill
depth.
Drill depth = distance between bottom edge of the feed gear and top edge of the depth
stop.
Drilling:
Please read and be sure to understand the drill motor instruction manual!
 Turn on the water tap or switch on the vacuum cleaner.
(There must at least be sufficient water pressure (max. 4 bar!) to move the arising drilling
mud from the borehole)
 Release the locking device (7) on the feed gear and use the hand wheel (8) to turn the drill
downward to the desired drill depth.
 Switch off the motor and crank back until the drill bit is completely visible.
In case of seizure, start up the drill motor again at low speed using cooling water
and withdraw the core bit.
In case of need, repeat the process or turn the core bit using the SW 41 flat wrench.
Please note: Switch off the RCD switch!
4

Care and maintenance

Upkeep, servicing and maintenance work must only be carried out when the system is at a
standstill.
The best maintenance measures involve the daily removal of sludge, dust and dirt. Special
attention must be paid to the guide column and sliding guide as well as to the gear rack and the
feed bevel. The spindle should be oiled lightly each time it is cleaned.
The sliding guides should be checked for play at regular intervals and re-adjusted if necessary.
Do not grease the drill column and gear rack as the grease takes effect as a grinding
paste together with the adherent dirt and increases wear.
Clean the adjusting screws on the base plate every day and keep them free-moving.
Important! All maintenance, overhauling and repair work must only be carried out by trained
specialised staff
5

Accessories

The relevant accessories and an order form can be found from Page 136 onwards.
6

Disposal

Components of the unit are recyclable material and should be put to recycling. For this purpose
registered and certified recycling companies are available. For an environmentalfriendly disposal
of the non-recyclable parts (e.g. electronic waste) please contact your local waste disposal
authority.
ENGLISH
15