Installing Magicspeed; Tools Required - Dometic MS 880 Instrucciones De Montaje

Installing MagicSpeed

7 Installing MagicSpeed
I
NOTE
If you do not have sufficient technical knowledge for installing and
connecting the components in vehicles, you should have a specialist
install the system in your vehicle.
7.1

Tools required

For installation and assembly and the electrical connection, you will need the
following tools fig. 1, page 3.
To fasten the module and the cables, you may need additional screws and cable
binders.
7.2 Installing the electronic module
I
NOTE
When selecting the installation location, observe the following
instructions:
• Install the electronic module
– behind the glove compartment
– behind the footwell on the driver or passenger side
– under the dashboard on the driver side
– not anywhere subject to heat or moisture
– not in the engine compartment
– not near high-voltage components
– not directly next to ventilator nozzles.
• Where possible, use existing holes in the vehicle.
A
NOTICE!
Before drilling holes, make sure the drill bit will not damage anything on
the other side (fig. 2, page 4).
➤ Select a suitable installation location (fig. 5, page 5).
Do not fasten the electronic module before you have decided where to lay the
cables.
➤ After finishing assembly, fasten the module to the selected position:
screw the electronic module securely to the vehicle with the screws supplied or
use double-sided adhesive tape.
16
MS880
EN