Attaching Ventilation Panel - Waeco FreshAir HDE Instrucciones De Montaje

Installation
Connecting outside the air conditioning roof unit (fig. 9, page 6)
➤ Connect the two-pin Metri-Pack sealed 280 plug to:
– Position A (1): positive terminal (red), protected by a 20 A fuse
– Position B (2): negative terminal (black)
Connecting the control panel (fig. 0, page 7)
➤ Connect the 5-pin black plug to the ventilation switch (1).
➤ Connect the 3-pin black plug to the temperature switch (2).
➤ Connect the green wire to the On/Off switch (3).
➤ Connect the red-black wire to On/Off switch (3).
6.2.6

Attaching ventilation panel

A
NOTICE!
Check prior to installation that there are no electrical cables or hoses
between roof and ventilation panel.
➤ Place the ventilation panel in the cabin under the roof (fig. a,
page 7).
Position the ventilation panel so that:
– the air inlet grill is under the air inlet opening (fig. b 1, page 7) of
the air conditioning roof unit
– the three air outlet nozzles are under the air outlet opening
(fig. b 2, page 7) of the air conditioning roof unit
I
NOTE
The length of the fastening bolts for the ventilation panel depends on the
thickness of the lining of the roof interior.
Make sure, before screwing the ventilation plate in place, that the length
of the bolts do not interfere with the air conditioning roof unit.
➤ Select fastening bolts (not included in scope of delivery) which are
appropriate for the roof thickness and the strength of the bodywork.
➤ Attach the ventilation plate (fig. b, page 7).
32
FreshAir HDE
EN