Using The Device - Waeco FreshAir HDE Instrucciones De Montaje

FreshAir HDE
2.1

Using the device

 The travel range of superstructures such as telescopic arms, booms,
side forks and other vehicle attachments must not be restricted.
 Only use the air conditioning roof unit for the purpose specified by the
manufacturer and do not make any alterations or structural changes
to the device.
 Do not use the air conditioning roof unit if it is visibly damaged.
 The air conditioning roof unit must be installed safely so that it cannot
tip over or fall down.
 Make sure the air conditioning roof unit is protected from overturning
or falling parts.
 Installation, maintenance and repair work may only be carried out by
qualified personnel from a specialist company who are familiar with
the risks involved and the relevant regulations.
 Do not use the air conditioning roof unit near flammable fluids and
gases.
 Do not operate the air conditioning roof unit if the ambient temperature
is below 0 °C.
 Do not undo the upper cover of the air conditioning roof unit in the
event of a fire. Use approved extinguishing agents instead. Do not use
water to extinguish fires.
 Please inquire from your vehicle manufacturer whether the height
entered in your vehicle documentation needs to be altered due to the
installation of the air conditioning roof unit (height 213 mm).
 Disconnect all power supply lines when working on the air conditioning
roof unit (cleaning, maintenance, etc).
EN
Safety instructions
25