Mounting The Adapter Frame; Attaching The Seal For The Cab Roof; Installing The Unit In The Sunroof - Waeco CoolAir CA850S Instrucciones De Instalación

CA-850S_EBA.book Seite 31 Freitag, 16. April 2010 6:46 18
Installation
6.2.3

Mounting the adapter frame

➤ Apply a flexible, non-hardening butyl sealing compound (e.g.
➤ Secure the adapter frame as shown in fig. 4 on page 4 with the 4
6.2.4

Attaching the seal for the cab roof

Caution
a
Ensure that the adhesive surface for the seal between the unit and the
cab roof is clean (free of dust, oil, etc.).
➤ Stick the 2.5 m insulating tape (10 x 20 mm) to the cab roof, following
➤ Provide the abutting edge and the top edge of the insulating tape with
6.2.5

Installing the unit in the sunroof

➤ Set the unit down centrally aligned and in the direction of travel (fig. 1
I Note
Make sure the air conditioning roof unit is centred perfectly. The seal must
be applied continuously around the air conditioning roof unit after being
placed on the roof of the vehicle. This is the only way to ensure a tight
seal.
➤ Place the spacer sleeve L = 22 mm (fig. 6 on page 5, item 1) on the
➤ Screw one hex screw M6 x 45 mm (fig. 6 on page 5, 4) with a wash-
Caution
a
Do not exceed the specified torque under any circumstances. This is the
only way to ensure that the thread inserts are not torn out.
➤ Tighten the screws with a torque of 6 Nm.
SikaLastomer-710) to the contact surface of the adapter frame
(surface with drill holes for fastening the frame) to the air conditioning
roof unit (fig. 4 on page 4, item 1).
rounded head screws with flange (M8 x 16 mm) (fig. 4 on page 4,
item 2).
the outline of the sunroof opening (fig. 5 on page 5).
an unhardened plastic butyl sealing compound (e.g.
SikaLastomer-710).
on page 3) on the sunroof opening.
fastening drill holes as shown in fig. 6 on page 5.
er 6.5 x 20 (fig. 6 on page 5, item 2) and spring washer M6 (fig. 6
on page 5, item 3) in the 14 thread inserts on the bottom of the unit.
CoolAir
31