Bosch GCM 10 Professional Manual Original página 41

OBJ_BUCH-1132-001.book Page 41 Thursday, January 28, 2010 10:16 AM
Ceiling Strips/Mouldings (According to US Standard)
When the ceiling strips/mouldings are to be sawn lying flat on the saw table, the
52°
standard mitre angles of 31.6° (horizontal) and 33.9° (vertical) must be set.
The following table contains instructions for sawing ceiling strips/mouldings.
38°
Settings
Vertical bevel angle
Ceiling strip/moulding
Inner corner Horizontal mitre
angle
Positioning of
workpiece
The finished
workpiece is lo-
cated...
Outer corner Horizontal mitre
angle
Positioning of
workpiece
The finished
workpiece is lo-
cated...
Bosch Power Tools
Placed
against
the fence
52°
0°
Left side Right side
45° right 45° left
Bottom edge Bottom edge
against the against the
fence fence
... to the right ... to the left of
of the cut the cut
45° left 45° right
Bottom edge Bottom edge
against the against the
fence fence
... to the right ... to the left of
of the cut the cut
English | 41
Lying flat
on the
saw table
33,9°
Left side Right side
31.6° right 31.6° left
Upper edge Bottom edge
against the against the
fence fence
... to the left of ... to the left of
the cut the cut
31.6° left 31.6° right
Bottom edge Upper edge
against the against the
fence fence
... to the right ... to the right
of the cut of the cut
1 609 929 W07 | (28/1/10)