Publicidad
Idiomas disponibles
Idiomas disponibles
After all parameters setting completed, click "Save" and then it comes into effect immediately.
PTZ setting
Network High Speed Dome "ePTZ Set" interface as figure 3-12.
Protocol: Pelco D supported only
Address: 0-255 adjustable, default is 1
Baud Rate: Baud rate 9600 supported only
Operation method: Connect analog high speed dome at the Network High Speed Dome AB port, set the protocol and baud rate,
and control the high speed dome through IPC preview interface
After all parameters setting completed, click "Save" and the it comes into effect immediately.
Display settings
Network High Speed Dome "Display settings" interface as figure 3-13.
Name:Modify the channel name
Time Format: Select different time display mode for the channel
Date Format: Select different date display mode for the channel
Bright: Adjust the brightness for the channel
Figure 3-12
Figure 3-13
11
Publicidad
Capítulos
